TM 11-5985-362-13
(3) ANCHOR (6) (RIGHT AND LEFT SIDES)
To locate position for right and left anchors using the BACK and CENTER LAYOUT WIRES proceed as follows:
With a crewmember at each end of the BACK LAYOUT WIRES (marker tag 7), third crewmember picks up SLEEVE
with marker tag 4.
Walk toward ANCHOR 1 (allowing the BACK LAYOUT WIRE to form a "V") until CLAMP NO. 4 is reached on
CENTER LAYOUT WIRE.
Insert SLEEVE with marker tag 4 into CLAMP NO. 4.
Tighten CLAMP wingnut securely.
One crewmember remains at CLAMP NO. 4 to hold wire in place.
Second crewmember proceeds to TOWER BASE to hold SLEEVE with marker tag 5 on arrowhead as pivot point.
Third crewmember obtains two 30 inch anchors from transit case and proceeds to ANCHOR 6.
2-19
Previous Page
