TM 11-5985-371-12&P
c. Insert the remaining three mast sections in the mast section racks in the two
end plates. Using the two straps attached to the mast section racks of the carrying
frame, strap the three mast sections in place.
.
.
END PLATE
(2)
4-24. Packing Carrying Case. Pack the carrying frame (para 4-23) and all remaining
components of the AS-3577/GRC into the carrying case.
a. Open the hinged cover of the carrying case.
b. Place the packaged carrying frame (para 4-23) to the right and back of the
carrying case.
c. Place the terminating resistor box inside the terminating resistor box stop
and place it at the left.
d. Place the 31 ground rods in the carrying case in front of the carrying frame.
e. Use the four lanyards as a cushion and place them over the ground rods.
f. Place the balun to the left, on top of the lanyards.
g. Place the following also on the lanyards:
(1) Goggles.
(2) Bag containing 6 conductor splices and electrical tape.
(3) Measuring tape, 100-foot.
(4) One roll of 2-inch warning strips, and 2 rolls of 3/4-inch warning
strips.
(5) One roll of antenna wire and the cable adapter.