TM 11-5985-371-12&P
WARNING
Do not try to raise the terminating resistor box to the top of the
mast during an electrical storm.
(5) Attach the slide hook
on the terminating resistor box
to the eyelet
. Pull the loose end of the halyard
to raise the ter-
on the halyard
until it reaches the terminating resistor stop
. Make
minating resistor box
sure the antenna wires are located between the middle and top guys. Tie the loose
end of the halyard
to the cleat
on the balun clamp
which mounts the
balun
to the mast.
(6) Attach one of the end loops
on one antenna wire from the connector A
on the terminating resistor box to the snap hook
on the lanyard
connected to
the antenna stake B
wire to the snaphook on the lanyard connected to antenna stake C. Attach one of the
end loops on the antenna wire from the connector B on the terminating resistor box
to the snaphook on the lanyard connected to antenna stake A and the other end loop
to the snaphook on the lanyard connected to antenna stake D.
4-22
Previous Page
