TM 11-5985-371-12&P
c. Replacement.
(1) Wrap each antenna wire
at the midpoint around each terminating
resistor box connector
on each side of the terminating resistor box
.
(2) Place and tighten a conductor splice
on the antenna wires
coming
from each terminating resistor box connector
(3) Replace the conductor splices forming the antenna loops that attach the
antenna wire to the four antenna stake lanyards (para 4-16).
(4) Engage the slide hook
on top of the terminating resistor box to the
eyelet on the halyard
.
, raise the terminating resistor box
on the mast
(5) Using the halyard
until the terminating resistor box
reaches the terminating resistor box
stop
.
(6) Tie the loose end of the halyard
to the cleat
on the balun clamp
(7) Connect the loose ends of the antenna wire to the balun (para 4-15b(2)).
(8) Connect the antenna wire end loops, formed with the conductor splices, to
(9) Notify the radio operator to reconnect the antenna rf cable to the radio.
4-18
Previous Page
