TM 11-5985-371-12&P
b. Replacement.
(1) Cut two 220-foot pieces of antenna wire from the 500-foot roll.
(2) Wrap one antenna wire at the midpoint (110 feet from each end) around
antenna connector
on the terminating resistor box
(terminal A will hold
the antenna wire going to antenna stakes B and C) (para 2-5e)). Place and tighten
a conductor splice
at the midpoint.
(3) Measure 60 feet from the midpoint of each loose end of the antenna wire,
make a loop, and place a conductor splice at each point. These loops will connect to
the snap hooks on the lanyards attached to antenna stakes B and C ((6) below).
(4) Repeat the procedures ((2) and (3) above) for the antenna wire to be con-
nected to terminating resistor box connector
(terminal B will hold the antenna
wire going to antenna stakes A and D (para 2-5e)).
Previous Page
