TM 11-5985-334-34
Figure 2-15. Bubble level removal.
Section IV. MAINTENANCE PROCEDURES MK-2044/G
2-22. Removal and Replacement of Winch Handle
2-23. Repair of Mast Carrier, MK-2044G
and Winch Studs, MK-2044/G
a. Drive pin (7) out of sleeve (8), and remove
a. Using a 0.187-inch pin punch, drive pin (4)
sleeve. End cap (1) may now be removed.
from hole in crank to release crank from winch.
b. Remove screws (6) to remove flange (9).
b. Using a 5/16-inch open-end wrench, unscrew
c. Remove screws (2) to remove stop (3).
two winch studs (3).
d. Unscrew nut (4) from stud (5).
2-21
Previous Page
