TM 32-5985-343-14&P
Figure 7-1. Scaffold Winch Assembly
(2) Detach chain guard (8) by removing four
bolts (16), nuts (17), three machine screws (19),
(1) Detach four cam follower mounting blocks
flatwashers (20), and nuts (21).
No. 1 (2) from elevator assembly (1) by removing two
(3) Remove four chain tension bolts (9), two
socket head cap screws (8 or 9) and lockwashers (7) for
cap bolts (5), and six chain tension jam nuts (6).
each mounting block.
(4) Locate and remove pin that connects both
(2) Detach four cam follower mount
ends of chain (7), and remove chain.
assemblies (4) from elevator assembly (1) by removing
two socket head cap screws (8 or 9) and lockwashers (7)
(5) Reel out hoist cable (24) and remove it
for each assembly.
from drum (3).
(3) For each cam follower mounting block No.
(6) Detach two upright caps (4) by removing
1 (2), remove two cam followers (3).
four bolts (1) and lockwashers (2).
(4) From each cam follower mount assembly
(7) Detach two bearing assemblies (22) by
(4), detach cam follower mounting block No. 2 (5) by
removing two bearing bolt locks (23) and eight
removing four socket head cap screws (6) and
lockwashers (15) and hex nuts (14). Remove drum (3).
lockwashers (7).
(5) Remove one cam follower (3) from each
cam follower mount assembly (4) and from each cam
(1) Detach four cam follower blocks (2) from
follower mounting block No. 2 (5).
antenna carriage assembly (1) by removing two bolts
f. Elevator Hoist. The elevator hoist is not to be
(4), nuts (5), and lockwashers (6) for each cam follower
disassembled.
block (2).
(2) Remove two cam followers (3) from each
for disassembly instructions for tower parts not given in
cam follower block.
this chapter.
7-2
Previous Page
