TM 11-5985-371-12&P
(2) Personnel.
At least two people must be available to install the antenna
assembly.
(3) Tools. All of the tools needed to install the antenna assembly are pro-
vialed with the assembly. A hammer, 100-foot tape measure, and 1/4 inch slotted screw-
driver are required.
See section II in chapter 4.
b. Unpacking Carrying Case.
c. Placement of Mast Base.
(1) Using the 100-foot tape measure, locate and mark the center of the
120-foot by 70-foot plot chosen for the antenna site.
WARNING
Wear protective goggles while driving the mast base into the ground.
(2) Place the square plate
on the ground at the center. Set the swivel
on the mast base such that its male connector
is at a right angle to its ground
held vertically. Place the ground stake
through the hole in the plate
stake
and point the swivel toward the center of the short side of the antenna site
(point A). Put on protective goggles. Hammer the ground stake
vertically into
the ground at the center of the antenna site. Remove the protective goggles.
Previous Page
