TM 11-5985-355-13
Figure 2-1. Antenna siting locations, good and poor.
pigtail should contain three to six twists.
NOTE
NOTE
There are three pairs of safety wire
holes in the cable mount; select the
Excess safety wire should be trimmed
particular pair for which the safety wire
and the pigtail bent back so that it lies
will be held in tension if the AS-
flat against the surface of the hexagonal
2732/GRC tends to loosen.
portion of the spring mount.
h. If applicable, connect the bonding jumper
g. Twist the two ends of the safety wire together
into a pigtail, keeping the safety wire in tension. The
2-2
Previous Page
