TB 11-5820-1148-10
Connect all of the spade lugs on the drop wires to the binding posts on the multi connector.
5.12 ONE SIDE OF ANTENNA FINISHED
Turn outward and face the load resistor in the outer antenna element wire. Unroll wire while walking
toward that outer resistor. The snap link end will appear, with only a drop lead and the number 4 on
the white band. Put the spool down and connect the snap ring to the bottom (downstream) side of the
resistor strong point. Now connect the upstream spade lug and then the two downstream lead spade
lugs at the binding post connections on the resistor (one upstream, and two downstream).
This is what the layout of the first side of the antenna should look like at this point in time.
1-21
Previous Page
