TB 11-5820-1148-10
5.2
INSERT A LOAD RESISTOR
While unrolling the wire, watch for a set of snap links. When you find them STOP, unhook the snap
links from each other. Insert a load resistor by connecting the snap links onto the strong points of the
load resistor, one to each end of the resistor. Slide the "O" rings on the antenna wires toward the snap
link. Connect the spade lugs to the binding posts, one to each end of the load resistor. Finish First
Wire Continue unrolling the antenna wire until you encounter the next set of snap links. Disconnect
the links and connect the snap link marked with #2 to the side of the multi connector, with the unused
bow shackle.
Pick up the stake and stretch the antenna element, resistor, multi connector, rope, and stake until the
antenna element is straight and lies in the intended direction of antenna orientation. DO NOT DRIVE
THE STAKE INTO THE GROUND AT THIS TIME. Return to the base of the mast.
5.3
LAY OUT SECOND ANTENNA WIRE
Attach the end of the next wire to the base of the mast as you did for the first wire. Unroll the wire until
you find two snap links connected together.
1-16
Previous Page
