TM 32-5985-343-14&P
CHAPTER 5
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. TOOLS AND EQUIPMENT
expendable materials and supplies. Tools and materials
5-1 TOOLS AND MATERIALS. Tools required for
required for organizational maintenance are listed in
organizational maintenance are listed in Appendix D,
Maintenance Allocation Chart. Refer to Appendix F for
Table 5-1. Organizational Maintenance Tools and Materials
Item
Use
Allen wrench, 3/8-inch
Removing and tightening socket head screws.
Torque wrench, 0-200 ft-lbs
Tightening attaching hardware.
Torque wrench, 0-600 ft-lbs
Tightening attaching hardware.
Bristle brush, 1-inch
Removing dust and dirt from hard-to-reach areas of metal parts and
applying trichloroethane to remove caked-on dirt from metal parts.
Cloth, lint-free
Removing dust and dirt from metal parts.
Trichloroethane
Cleaning caked-on dirt and grease from metal parts.
Section II. REPAINTING AND REFINISHING INSTRUCTIONS
Painting and Preserving Electronics Command
5-2 GENERAL. The tower is often exposed to weather
Equipment Including Camouflage Pattern Painting of
conditions (rain, snow, and ice) that cause rust and
Electrical Equipment Shelters, shall be followed to
corrosion of the tower elements. Repaint or refinish
repaint the tower units. The paints and finishes shall be
these parts when extensive rust and corrosion are found
those specified in SB 11-573, Painting and Preservation
during routine and periodic maintenance inspections.
Supplies Available for Field Use for Electronics
Command Equipment. Refer also to TM 43-0139,
5-3
PROCEDURES
AND MATERIALS.
The
Painting Instructions for Field Use.
procedures given in TB 43-0118, Field Instructions for
5-1
Previous Page
