TM 11-5985-362-13
CAUTION
When removing TOWER SPLICES, be careful not to unwind TOWER SPLICE nuts too
far. The threads at the end of the bolts have been upset to prevent loss of nuts.
Remove GIN POLE from TOWER/GIN POLE BASE.
Remove TOWER TOP PLATE, TOWER TRANSITION PLATE, GIN POLE TOP PLATE and TOWER
SPLICES from all TOWER and GIN POLE SECTIONS.
Remove TOWER/GIN POLE BASE from TOWER BASE.
Release TOWER BASE from ground by removing four TOWER BASE PINS.
From transit case, obtain REEL NO. 1 and starting at the loop end of STAINLESS STEEL TOWER GUY,
wind it onto reel.
Starting at the loop end of the two MIDDLE TOWER GUYS, wind them one at a time onto REEL NO. 1.
Obtain REEL NO. 4 and wind the SIDE LAYOUT WIRE, then BACK LAYOUT WIRE and then CENTER
LAYOUT WIRE onto reel.
Remove all screw-in and pound-in ANCHORS.
2-64
Previous Page
