TM 11-5821-284-34
Step
Test equipment
no.
control settings
Test point
Test procedure
Performance standard
waveforms shown in
J2-K and observe
Capacitor actuator arm
figures 6-8V and 6-8W.
waveform.
moves in when switch
AN/ARM-11S METER
is thrown.
FUNCTION: OFF.
b. Remove ground from pin
b. Waveform is same as
MANUAL TUNE: OFF.
10 and ground pin 12
that shown in figure
MV ADJUST: fully ccw.
of circuit board A1.
6-4W. T2 is 25 t15
Observe waveform at
ms. Capacitor actuator
JZ-K.
arm moves out when
switch is thrown.
c. Remove ground from
c. None.
Figure 3-1. Test connections, antenna vswr test.
Figure 3-2. Test connections, manual cycle and run signal test.
3-5
Previous Page
