(5) Stake C Guys. The snaphooks on the guys to be connected to guy stake C
are connected to the guy holes in the guy Plates opposite the guy holes
occupied by the snaphooks on the stake A guys
Attach the snaphook on the
remaininq red guy
to the C guy hole in the top guy plate
Attach the snap-
hook on the remaining white guy
to the C guy hole in the center guy plate
Attach the remaining blue guy
to the C guy hole in the bottom guy plate
Stretch the guys along the mast toward guy stake C
The guys are not connected
to guy stake C
until after the mast is raised (j below).
Do not try to raise the mast during an electrical storm or when a
storm is imminent.
Do not try to raise the mast without at least two people.
When raising the mast, allow only the personnel involved in
raising the mast in the area.
If the antenna must be erected when the ground is wet, frozen or
slippery or the wind is blowing at a rate greater than 15 miles
per hour (13 knots), at least four people (two at each location)
should be available.