TM 11-6625-1702-12
C1
g. Illustrations Column.
d. Unit of Issue Column. The unit used as a
(1) Figure number column (a) The number
basis of issue; that is, ea, pr, ft, yd, etc., is indi-
of the illustration in which the item is shown
cated in this column.
appears in this column.
e. Quantity Incorporated in Unit Column. T h e
(2) Item or reference designation column (b).
quantity of repair parts in an assembly is given
The callout number or reference designation used
in this column. Subsequent appearances of the
to reference the item in the illustration appears
same item in the same assembly are indicated
in this column.
by the letters REF.
f. Maintenance Allowance Column.
D-4. Location of Repair Parts
(1) The allowance column is divided into
a. This appendix contains three cross-reference
subcolumns. Indicated in each subcolumn, oppo-
indexes (sees V, VI, and VII) to be used to locate
site the first appearance of each item, is the total
a repair part when either the Federal stock num-
quantity of items authorized for the number of
her, reference number (manufacturer's part num-
e q u i p m e n t s supported. Subsequent appearances
ber), figure number, or reference designation is
of the same item have no entry in the allowance
known. The first column in each cross-reference
columns, but have a reference in the description
index is prepared, as applicable, in numerical or
column to the first appearance of the item. Items
alphanumerical sequence. The last column of each
authorized for use as required, but not for initial
cross-reference index lists the index number as-
stockage, are identified with an asterisk (*) in the
signed to the part.
allowance column.
b. Refer to the appropriate cross-reference
( 2 ) The quantitative allowances for orga-
index (para D-2d, e, f, ) and note the index number
n i z a t i o n a l category of maintenance represents
in the last column; then refer to the repair parts
one initial prescribed load for a 15-day period for
list to locate the index number which is listed in
the number of equipments supported. Units and
ascending order in column 1 of the repair parts list.
o r g a n i z a t i o n s authorized additional prescribed
loads will multiply the number of prescribed loads
D-5. Federal Supply Codes
a u t h o r i z e d by the quantity of repair parts re-
This paragraph lists the Federal supply code and
flected in the appropriate density column to ob-
the associated manufacturers name.
tain the total quantity of repair parts authorized.
( 3 ) Subsequent changes to organizational
Manfacturer
Code
13499
Collins Radio Co.
allowances will be limited as follows: No change
70903
Belden Mfg. Co.
in the range of items is authorized. If additional
71744
Chicago Miniature Lamp Works.
items are considered necessary, recommendations
76545
Mueller Electric Co.
should be forwarded to Commanding General,
77820
Bendix Corp.
U. S. Army Electronics Command, ATTN:
The Electrical Components Division.
80058
A M S E L - M E - N M P - A C , Fort Monmouth, N.J.
Joint Electronic Type Designation System.
Army Electronics Command.
80063
07703, for exception or revision to the allowance
Military Specification.
81349
list. Revisions to the range of items authorized
Herman H. Smith, Inc.
83330
will be made by the USA ECOM National Main-
Military Standards.
96906
tenance Point based upon engineering experience,
demand data, or TAERS information.
Section Il.
PRESCRIBED LOAD ALLOWANCE
(1)
(3)
(2)
15-day org maint. alw
(D)
(c)
(B)
Description
(A)
Federal
stock
51-100
6-20
21-50
useable on code
1-5
no.
2
2
5920-855-4260
F U S E , CARTRIDGE: 81349, FO28125V2AS
2
2
6240-080-2012
L A M P , INCANDESCENT: 71744, 327AS15
D-2