C 1, TM
11-6625-1702-12
APPENDIX D
ORGANIZATIONAL MAINTENANCE REPAIR PARTS
INTRODUCTION
Section I.
the part. Listed in ascending order directly below
D-1. Scope
the SMR codes is the index number assigned to
This appendix contains a list of repair parts and
the repair part.
special tools required for the performance of orga-
(1) Source code. The selection status and
z a t i o n a l maintenance for Test Set, Antenna,
source for the listed item is noted here. Source
AN/ARM-115.
codes and their explanations are as follow-s:
D-2. General
Explanation
code
P -- Applies to repair parts that are stocked in or
This repair parts and special tools list is divided
supplied from the GSA / DSA or Army supply
into six sections.
system and authorized for use at indicated
a. Prescribed Load Allowance List (PLA) Sec-
maintenance categories.
tion II. The PLA is a consolidated listing of repair
Xl -- Applies to repair parts that are not procured or
parts allocated for initial stockage at organiza-
stocked, the requirements for which will be
supplied by the use of next higher assembly
t i o n a l maintenance level. This is a mandatory
or component.
minimum stockage allowance.
b. Special Tools, Test, and Support Equipment
(2) Maintenance code. The lowest category of
for Organizational Maintenance, Section III. N o t
maintenance authorized to install the listed item
applicable.
is noted here.
c. Repair Parts for Organizational Maintenance,
Explanation
Code
Section IV. Repair parts authorized for organi-
O Organizational Maintenance
zational maintenance are included in this section.
(3) Recoverability code. The information in
this column indicates whether unserviceable items
Note
should be returned for recovery of salvage. Re-
All indexes noted below are cross ref-
coverability codes and their explanations are as
erenced to index numbers. The index
follows :
numbers appear in ascending sequence
Note
in column 1 of the repair parts list (para
When no code is indicated in the re-
D-3a). The index number for the par-
coverability
column,
the
part
is
con-
t i c u l a r item will be the same for the item
sidered expendable.
in all sections of this appendix.
d. Index Figure and Item Number Cross Refer-
Explanation
Code
ence to Index Number, Section V. This is a cross
R -- Applies to repair parts and assemblies that are
economically repairable at DSU and GSU
reference of figure and item numbers to index
activities and normally are furnished by
numbers.
supply on an exchange basis.
e. Index Reference Designation Cross Reference
b. Federal Stock Number, Column 1, Section II,
to Index Number, Section VI. This is a cross refer-
Column 2, Sections III and IV. The Federal stock
ence of reference designations to index numbers.
number for the item is indicated in this column.
j. Index Federal Stock Number Cross Reference
c. Description, Column 2, Section II, Column 3,
to Index Number, Section VII. This is a cross ref-
Sections III and IV. The Federal item name, a
erence of Federal stock numbers to index numbers.
5-digit manufacturers code, and a part number
D-3. Explanation of Columns
are included in this column. For subsequent ap-
p e a r a n c e s of the same item the manufacturers
An explanation of the columns is given below.
a. Source, Maintenance, and Recoverability Codes
code and part number are omitted. The words
(SMR) and Index Numbers Column. The first line
SAME AS, followed by the sequence number as
it first appeared in the list, follow the item name.
in this column lists the applicable SMR codes for
D-1