..
TM 11-5985-371-12&P
(2) Untie the loose end
of the halyard from the cleat
on the balun
clamp
and lower the terminating resistor box
. Disengage the slide hook
on the terminating resistor box
from the eyelet
on the halyard.
on the four lanyards
(3) Unsnap the snaphooks
and disconnect the
from the four lanyards. Remove the three conductor splices
antenna wire loops
on each antenna wire
, and pull the antenna wire through the terminating
. Remove and coil the lanyards. Remove the
from the four antenna stakes
four antenna stakes from the ground, and separate the ground rods.
2-26
Previous Page
