TM 32-5985-342-14&P
APPENDIX E
REPAIR PARTS AND SPECIAL TOOLS LIST
Section I. INTRODUCTION
E-1 SCOPE. This appendix lists spares and repair
Code
Definition
parts; special tools; special Test, Measurement, and
Diagnostic Equipment (TMDE), and other special
PA -
Item procured and stocked for anticipated or
support equipment required for performance of
known usage.
organizational and direct support maintenance of the
Antenna Tower TS-9A. It authorizes the requisitioning
AD -
Item to be assembled at depot maintenance
and issue of spare and repair parts as indicated by the
level.
source and maintenance codes.
XD
-
A support item that is not stocked. When
E-2 GENERAL. This Repair Parts and Special Tools
required, item will be procured through
List is divided into the following sections:
normal support channels.
NOTE
and repair parts authorized for use in the performance of
Cannibalization or salvage may be
maintenance. The list also includes parts which must be
used as a source of supply for any
removed for replacement of the authorized parts. Parts
items coded above except those
lists are composed of functional groups in numeric
sequence, with the parts in each group listed in figure
coded XA and aircraft support items
and item number sequence.
as restricted by AR 700-42.
(2) Maintenance
Code.
Maintenance
codes
are assigned to indicate the levels of
maintenance authorized to USE and REPAIR support
items. The maintenance codes are entered in the third
Number Index. A list, in National Item Identification
and fourth positions of the uniform SMR code format as
Number (NIIN) sequence, of all National Stock Numbers
follows:
(NSN) appearing in the listings, followed by a list in
alphanumeric sequence of all part numbers appearing in
(a) The maintenance code entered in
the listings. National stock numbers and part numbers
the third position will indicate the lowest maintenance
are cross-referenced to each illustration figure and item
level authorized to remove, replace, and use the support
number appearance.
item. The maintenance code entered in the third
position will indicate one of the following levels of
E-3 EXPLANATION OF COLUMNS.
maintenance:
a. Illustration. This column is divided as follows:
Code
Application/Explanation
(1) Figure Number.
Indicates the figure
O
-
Support item is removed, replaced, used at
number of the illustration on which the item is shown.
the organizational level.
(2) Item Number.
The number used to
F
-
Support item is removed, replaced, used at
identify item called out in the illustration.
the direct support level.
b. Source, Maintenance, and Recoverability (SMR)
(b) The maintenance code entered in
Codes.
the fourth position indicates whether the item is to be
repaired and identifies the lowest maintenance level
(1) Source Code. Source codes indicate the
with the capability to perform complete repair; i.e., all
manner of acquiring support items for maintenance,
authorized maintenance functions. This position will
repair, or overhaul of end items. Source codes are
contain one of the following maintenance codes:
entered in the first and second positions of the uniform
SMR code format as follows:
E-1