TM 11-5985-371-12&P
(5) Connecting Antenna Wire to Balun. Connect the two loose ends
of the
piece of antenna wire (going to antenna stakes B and C) to antenna connector A
. Connect the two loose ends
of the other piece of
on top of the balun
antenna wire (going to antenna stakes A and D) to antenna connector B
.
WARNING
If the antenna is to be connected
to a transmitter, make certain
that the transmitter is not
transmitting and will not be
turned on prior to connecting the
rf cable/cables between the
antenna and the transmitter.
CAUTION
Route the rf cable from the
antenna assembly to the
receiver/transmitter so that it
will not be damaged by vehicles.
1. Connecting Rf Cables.
Remove the protector cap
from the
connector
on the bottom of the
. Tie one end of one of the
balun
100-foot (30.5 meter) rf cables
to
the mast base
, leaving enough of the end of the cable
to connect the cable
to the balun. If the other end of the 100-foot rf cable does not reach the connec-
tor on the transmitter/receiver, use the cable adapter
to connect a second
100-foot rf cable.
2-18
Previous Page
