TM 11-6625-1702-12
f. Column 6, Remarks. Column 6 contains an
d. Column 4, Maintenance Category. Column 4
alphabetic code which leads to the remark in sec-
specifies, by the listing of a "worktime" figure in
tion IV, Remarks, which is pertinent to the item
the appropriate subcolumn(s), the lowest level of
opposite the particular code.
maintenance authorized to perform the function
listed in column 3. This figure represents the ac-
C-4. Tool and Test Equipment Require-
tive time required to perform that maintenance
ments (Section III)
f u n c t i o n at the indicated category of mainte-
a. Tool or Test Equipment Reference Code. The
nance. If the number or complexity of the tasks
numbers in this column coincide with the num-
within the listed maintenance function vary at
bers used in the tools and equipment column of the
d i f f e r e n t maintenance categories, appropriate
"worktime" figures will be shown for each cate-
MAC. The numbers indicate the applicable tool or
test equipment for the maintenance functions.
gory. The number of task-hours specified by the
b. Maintenance Category The codes in this col-
"work time" figure represents the average time
umn indicate the maintenance category allocated
required to restore an item (assembly, subassem-
the tool or test equipment.
bly, component, module, end item or system) to a
c. Nomenclature. This column lists the noun
serviceable condition under typical field operating
n a m e and nomenclature of the tools and test
conditions. This time includes preparation time,
equipment required to perform the maintenance
t r o u b l e s h o o t i n g time, and quality assurance/
functions.
quality control time in addition to the time re-
d. National/NATO Stock Number. This column
quired to perform the specific tasks identified for
l i s t s the National/NATO stock number of the
t h e maintenance functions authorized in the
specific tool or test equipment.
maintenance allocation chart. Subcolumns of col-
e. Tool Number. This column lists the manufac-
umn 4 are as follows:
turer's part number of the tool followed by the
C -- Operator/Crew
Federal Supply Code for manufacturers (5-digit)
O -- Organizational
in parentheses.
F -- Direct Support
H -- General Support
C-5. Remarks (Section IV)
D -- Depot
a. Reference Code. This code refers to the ap-
e. Column 5, Tools and Equipment. Column 5
propriate item in section II, column 6.
specified by code, those common tool sets (not in-
b. Remarks. This column provides the required
dividual tools) and special tools, test, and support
e x p l a n a t o r y information necessary to clarify
e q u i p m e n t required to perform the designated
items appearing in section II.
function.